Topcom BUTLER 4056C User Manual
Page 21
Topcom Butler 4056/4056C
21
Topcom Butler 4056/4056C
ENGLIS
H
•
‘SEARCHING’ and the symbol appears on the display.
•
The RFPI code (each base unit has a unique RFPI code) appears on the display and a
signal sounds when the handset has found the base unit.
•
Press the Programming key
.
•
‘PIN’ appears on the display.
•
Enter the 4-digit PIN code of the base unit in (default PIN code is ‘0000’). Use the
number keypad.
•
Press the Programming key
.
•
The handset is subscribed to the base unit.
4.24 Subscribing Butler 4056 handset on another base (other brand/model)
Put the base in subscription mode (see manual of the base). If the base is in subscribing
mode, you have to do the following to subscribe the handset:
•
Press the Programming key
.
•
Press the Up or Down key
repeatedly until ‘BASE SUB’ appears on the display.
•
Press the Programming key
.
•
‘BASE _‘ appears on the display.
•
Enter a number for the base unit to which you would like to subscribe the handset (1-4).
•
Use the number keypad.
•
‘SEARCHING’ and the symbol appear on the display.
•
The RFPI code (each base unit has a unique RFPI code) appears on the display and a
signal sounds once the base unit is found by the handset.
•
Press the Programming key
.
•
‘PIN’ appears on the display.
•
Enter the 4-digit PIN code of the base unit (default PIN code is ‘0000’). Use the number
keypad.
•
Press the Programming key
.
•
The handset is subscribed to the base unit.
4.25 Removing subscription of a handset to a base unit
It is possible to cancel subscription of a handset to a base unit. You would do this if a
handset is damaged and has to be replaced by a new one.
Caution: You can only cancel subscription of another handset, not the handset you
are using to do the cancellation procedure.
•
Press the Programming key
.
•
Press the Up or Down key
repeatedly until ‘SETTING’ appears on the display.
•
Press the Programming key
.
•
Press the Up or Down key
repeatedly until ‘REMOVE HS’ appears on the display.
•
Press the Programming key
.
•
‘PIN’ appears on the display.
•
Enter your 4-digit PIN code in (default PIN code is ‘0000’). Use the number keypad.
•
Press the Programming key
.