SEVERIN KS 9886 - Manual (Page 13)

13
Problem
The appliance is connected to the mains
but fails to operate properly.
Abnormal noise can be heard during
operation.
When opening the door, the rubber seal
pops out.
Water collects on the bottom of the
cabinet.
Possible cause and solution
The wall socket has no power, or there are
contact problems. Check the wall socket
and the plug.
Either the unit has been improperly set up
(e.g. on an uneven floor) or there is contact
between the rear-mounted cooling circuit
and the power cord, the wall or other
object or surface. Verify that all
installation instructions in this manual
have been complied with.
The seal must be re-fitted properly, by
pressing in the inner part of the seal. If the
seal shows signs of a greasy residue, the
seal and the door must be properly cleaned
with water and a mild detergent, and then
thoroughly dried before the seal is
replaced on the door.
The melt-water drain system is blocked.
Remove blockage and clean the drain
system.
Transporting the appliance
The unit must be transported only in its vertical position.
Do not tilt it any more than 30°. During transport, ensure that the unit is properly secured
and protected against shock, vibration and shifting.
Disposal
This appliance has been manufactured from recyclable materials. After removing the
plug from the wall socket, the unit should be rendered unusable by cutting off the
power cord before being disposed of through special waste collection points in
accordance with local regulations. The refrigerant and the chemical agent in the insulation
foam must be disposed of through a competent agency. Take special care not to damage the
cooling circuit before the unit is handed over for competent disposal.
Guarantee
This product is guaranteed against defects in materials and workmanship for a period of two
years from the date of purchase. Under this guarantee the manufacturer undertakes to
repair or replace any parts found to be defective, providing the product is returned to one of
event of operational problems, check first whether a solution can be found using this table. If
the problem persists, disconnect the appliance from the mains power and contact our
Customer Service Department.