Tyco F3200 - Manual (Page 114)

F3200 Installation & Programming Manual Document No: LT0122
Programming System Configuration
Page 7-12 5 July 2001 Issue 2.7
MAPPING ZONES TO LEDS (CONTINUED)
For this reason, when changing zone to LED mapping it is necessary to disable the LED
mapping of the zone/relays (by selecting LED 0) which have a default mapping to the LEDs
which other zones are to be mapped to. (It is suggested that the programmer works from
largest zone number to smallest for this).
The LEDs on the 16 Zone LED display board may also be controlled by an output logic
equation. This is described in section 7.4.8. Any of the LEDs which are controlled by output
logic should not be mapped to by zones or relays.