TRENDnet TEG-PCBUSR - Manual (Page 4)

3
Card Insertion and Removal
Card Insertion
Follow these steps to install the 32-bit CardBus
10/100/1000Mbps Gigabit Ethernet PC Card:
[1] Insert the 32-bit CardBus 10/100/1000Mbps Gigabit
Ethernet PC Card
Find/select an available Type II or Type III 32-bit PC Card
slot on your notebook’s side or rear panel. Holding the 32-bit
CardBus 10/100/1000Mbps Gigabit Ethernet PC Card with
the LED indicator facing up then insert to the 32-bit PC Card
slot. Slide the 32-bit CardBus 10/100/1000Mbps Gigabit
Ethernet PC Card all the way into the 32-bit PC Card slot
until it reaches a firm stop.
4
[2] Connect to the Network Media
Simply plug one end of the cable (RJ-45 connector) into an
available hub/switch port, and plug the other end (RJ-45
connector) into the RJ-45 port of your 32-bit CardBus
10/100/1000Mbps Gigabit Ethernet PC Card.
Card Removal
Use the computer's PC Card Eject mechanism to unseat the
32-bit CardBus 10/100/1000Mbps Gigabit Ethernet PC Card
from the computer's PC Card slot. The PC Card will then
protrude from the PC Card slot and you can easily remove
the PC Card by gripping its protruding end and withdrawing
it from the PC Card receptacle.