Topcom BUTLER 1410 - Manual (Page 71)

- The 2nd handset will only be automatically called if 2 handsets are
subscribed. If more than 2 handsets are subscribed:
• 'INT XXXXX' appears on the display. XXXXX are the numbers of the
handsets which can be called (e.g. 'INT-23--' only handset 2 and 3 can be
called).
• Dial the number of the handset you would like to call. Or press the
‘BACK’ key (Softkey 1) to leave the menu.
- After finishing your call, press the Line key to hang up or put the
handset back on the base unit.
4.5. Switching the hands-free function on/off
This function allows you to have a telephone conversation without holding the
receiver.
There are two ways of activating the hands-free function:
1. During a call:
- Press the Menu key during a call.
- ‘HANDSFREE’ appears on the display.
- Press the 'ON' key to activate the hands-free function or press 'BACK' to go
back.
- Press the 'OFF' key to switch off the hands-free function.
Caution: Using the hands-free function for a long time causes the battery to drain faster.
2.When the handset is placed in the charger:
- Press the Line key
and the telephone will automatically accept the call in
hands-free mode. When you take the handset out of the charger, hands-free
mode automatically switches to normal calling.
4.6. Setting the speaker volume
Use the Volume key to set the volume of the speaker (handset).
You can choose from 3 levels: Volume 1, 2 and 3.
During a call, you can change the volume as follows:
- Repeatedly press the Volume key.
- The current volume level appears on the display.
4.7. Call Duration Indicator on the Display
During a call the call duration appears on the display (hours:minutes:seconds).
E.g. " 01:02:30" for 1 hour, 2 minutes and 30 seconds.
The call duration remains visible on the display for 5 seconds after each call.
Butler 1410
71
Butler 1410
71
Butler 1410
71
Butler 1410
71
handl. B1410 10/9/01 10:39 am Page 71