Topcom BUTLER 1410 - Manual (Page 84)

Butler 1410
84
Butler 1410
84
Butler 1410
84
- Repeatedly press the Menu key until ‘PRIORITY XXX" appears.
- Press 'EDIT' to change the setting or ‘BACK’ to go back.
- Enter the base unit PIN code (0000).
- Press 'OK' or ‘BACK’ to go back.
- The numbers of the subscribed handsets appear on the display.
- Enter the number of the handset which must ring first or press 'ALL' to have
all handsets ring together.
- Press 'OK' or ‘BACK’ to go back.
- When you have entered a handset number you must set the delay in
number of ringing tones:
- Repeatedly press the Menu key to change the number of ringing tones (1-9).
- Press 'SAVE' or ‘BACK’ to go back.
4.28. Pulse/tone setting
The telephone is set to tone dialling by default. However, if your system works
with pulse dialling you can switch to pulse dialling mode (in most cases this
will not be necessary).
- Repeatedly press the Menu key until 'TELEPHONE' appears.
- Press the OK key.
- Repeatedly press the Menu key until ‘BS SETTINGS’ appears.
- Press 'OK' or ‘BACK’ to go back.
- Repeatedly press the Menu key until ‘DIAL CONFIG’ appears.
- Press 'OK' or ‘BACK’ to go back.
- Repeatedly press the Menu key until ‘DIAL MODE’ appears. The current
setting is also displayed.
- Press 'CHANGE' to change the setting or ‘BACK’ to go back.
- Enter the base unit PIN code (0000).
- Press 'OK' or ‘BACK’ to go back.
- Press the Menu key to switch between tone and pulse dialling.
- Press 'OK' to confirm your selection or 'BACK' to go back.
4.29. Setting the flash time
You can set the flash time on 100, 300 or 600ms:
- Press the Menu button a few times until ‘TELEPHONE’ appears on the
display.
- Press the OK button.
- Press the Menu button a few times until ‘BS SETTINGS’ appears on the
display
- Press the OK button or ‘BACK’ to return.
- Press the Menu button a few times until ‘DIAL CONFIG’ appears on the
display
Butler 1410
84
handl. B1410 10/9/01 10:39 am Page 84