Toshiba MW24FN3/R - Manual (Page 46)

46
Other functions (VCR)
Second Audio Program (SAP)/
Stereo recording and playback
When a MTS STEREO broadcast
is received, “STEREO” will appear
on the screen and the program
can be viewed or recorded in ste-
reo.
The Hi-Fi stereo recording proce-
dure is the same as for normal
recordings.
Notes:
• When playing back a tape that is not recorded in Hi-Fi stereo
mode, the audio will automatically be monaural.
• When listening to a VHS Hi-Fi video tape or MTS broadcast
through the VHF/UHF jack (Audio/Video cord not connected),
the sound will be monaural.
When viewing an MTS stereo TV program, or playing a
prerecorded VHS Hi-Fi stereo videotape, press AUDIO
SELECT to select how the audio will be heard through the
speakers. Normally set to the Hi-Fi stereo position, this
button can be set to the MONO position if the stereo
broadcast or videotape audio is of poor quality. The “R”
and “L” positions allow the audio from the Right or Left
Hi-Fi channel to be heard over both TV speakers. This
button has no effect when viewing a MONO videotape or
TV program. Each time when you press the button,
OUTPUT SELECTION display appears on the screen for
several seconds. Refer to the chart below.
Output selection
Your unit is fitted with a SAP broadcast system which enables
you to switch to a Second Audio Program when viewing a se-
lected channel.
This function applies only when the program is broadcast in
multi-languages through the SAP broadcast system.
When the unit is turned on or a channel selection is made,
make certain the letters “SAP” appears on the screen.
This means that the “Second Audio Program” broadcast-
ing is available.
Listening to SAP
Stereo recording and playback
The VHS Hi-Fi audio system permits high fidelity recording of
MTS STEREO TV broadcasts.
Second Audio Program (SAP)
OUTPUT
SELECTION
STEREO
L ch
R ch
MONO
SOUND HEARD ON BOTH
SPEAKERS
STEREO
LEFT CHANNEL AUDIO
RIGHT CHANNEL AUDIO
MONO
Press MENU. Press or to select “TV SETUP”,
then press ENTER. 1
Press or to select “SAP”. Then press
ENTER to select “ON”.
Then press MENU repeatedly until
the menu screen is cleared.
2
STEREO
STEREO SAP SAP
OR
Note:
When using a CATV system, stereo TV programs may be
transmitted over a mono cable channel. In this case
“STEREO” will not appear and the sound will be in mono.
AUDIO
SELECT
SETUP
MENU
SETUP
MENU
1-2
1-2
1-2
ENTER
ENTER
AUDIO SELECT
M E N U
TIMER REC SET
TV SETUP
CH SETUP
AUTO REPEAT ON OFF
SYSTEM SETUP
〈 / /ENTER/MENU 〉
TV SETUP
V-CHIP SET
ON/OFF TIMER
PICTURE
AUDIO
SURROUND
STABLE SOUND
SAP
ON OFF
ON OFF
ON OFF
〈 / /ENTER/MENU 〉
5F10201C (E)p46-47 5/6/03, 16:53 46