Which setup parameters to use, Changing the setup parameters, From the home screen or a program – Texas Instruments PLUS TI-89 User Manual

Page 242

Advertising
background image

Chapter 13: Tables 225

13TABLES.DOC TI-89/TI-92 Plus: Tables (English) Susan Gullord Revised: 02/23/01 1:08 PM Printed: 02/23/01 2:16 PM Page 225 of 10

To generate:

tblStart

@

tbl

Graph <

-

> Table

Independent

An automatic table

¦

Based on
initial values

value

value

OFF

AUTO

¦

That matches
Graph screen

—

—

ON

AUTO

A manual table

—

—

—

ASK

“—” means that any value entered for this parameter is ignored for
the indicated type of table.

In

SEQUENCE

graphing mode (Chapter 9), use integers for

tblStart

and

@

tbl

.

From the

TABLE SETUP

dialog box:

1. Use D and C to highlight the value or setting to change.

2. Specify the new value or setting.

To change:

Do this:

tblStart

or

@

tbl

Type the new value. The existing value is
erased when you start to type.

— or —

Press A or B to remove the highlighting.
Then edit the existing value.

Graph <

-

> Table

or

Independent

Press A or B to display a menu of valid
settings. Then either:

¦

Move the cursor to highlight the
setting and press ¸.
— or —

¦

Press the number for that setting.

3. After changing all applicable values or settings, press ¸ to

save your changes and close the dialog box.

You can set up a table’s parameters from the Home screen or a
program. You can:

¦

Store values directly to the system variables

tblStart

and

@

tbl

.

Refer to “Storing and Recalling Variable Values” in Chapter 2.

¦

Set

Graph <

-

> Table

and

Independent

by using the

setTable

function. Refer to Appendix A.

Which Setup
Parameters to Use

Changing the
Setup Parameters

Tip: To cancel a menu or
exit the dialog box without
saving any changes, press

N

instead of

¸

.

From the Home
Screen or a Program

Advertising
This manual is related to the following products: