Troubleshooting, General, Ipod player – Teac GR-7i User Manual

Page 25: Tuner, Maintenance

Advertising
background image

ENGLISH

25

Troubleshooting

If you have problems with your system, look
through this chart and see if you can solve
the problem yourself before calling your
dealer or TEAC service center.

General

No power

e

Check the connection to the AC power
supply. Check and make sure the AC
source is not a switched outlet and
that, if it is, the switch is turned on.
Make sure there is power to the AC
outlet by plugging another item such as
a lamp or fan into the outlet.

No sound from speakers.

e

Select the source by pressing the
iPod/shuffle, AUX or TUNER (FM/AM)
button.

e

Adjust the volume.

e

Pull out the headphone’s plug from the
PHONES jack.

e

Check if the sound is muted. If that is the
case, press the MUTING button again.

The sound is noisy.

e

The unit is too close to a TV or similar
appliances. Install the unit apart from
them, or turn them off.

Remote control doesn’t work.

e

Press the STANDBY/ON button to turn
the unit on.

e

If the battery is exhausted, replace it
with a new one.

e

Use remote control unit within the
range (5 m) and point at the remote
sensor on the front panel.

e

Clear obstacles between the remote
control unit and the main unit.

e

If a strong light is near the unit, turn it
off.

iPod Player

Cannot insert the iPod.

e

Check the dock adapter.

e

Remove dust or obstacles from the
Dock connector of the GR-7i and the
iPod, and insert the iPod again.

Will not play.

e

Remove the iPod from the dock, wait a
few seconds, and insert it again.

e

Software update may solve the
problem. Visit the Apple website and
download the latest iPod Software.

Cannot operate the iPod.

e

Set the HOLD switch of the iPod to off.

Tuner

Cannot listen to any station, or signal is
too weak.

e

Tune in the station properly.

e

Rotate the FM or the AM antenna until
you get stations clearly.

If normal operation cannot be resumed,
unplug the power cord from the outlet
and plug it again.

Maintenance

If the surface of the unit gets dirty, wipe
with a soft cloth or use a diluted mild
liquid soap. Be sure to remove any excess
liquid completely. Do not use thinner,
benzine or alcohol as they may damage
the surface of the unit. Allow the surface
of the unit to dry completely before
using.

Advertising