Teac GR-7i - Manual (Page 4)

4
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
CAUTION
< DO NOT REMOVE THE EXTERNAL CASES
OR CABINETS TO EXPOSE THE
ELECTRONICS. NO USER SERVICEABLE
PARTS ARE WITHIN!
< IF YOU ARE EXPERIENCING PROBLEMS
WITH THIS PRODUCT, CONTACT TEAC FOR
A SERVICE REFERRAL. DO NOT USE THE
PRODUCT UNTIL IT HAS BEEN REPAIRED.
< USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION
EXPOSURE.
< Do not expose this apparatus to dripps or
splashes.
< Do not place any objects filled with liquids,
such as vases, on the apparatus.
< Do not install this apparatus in a confined
space such as a book case or similar unit.
< The apparatus draws nominal non-
operating power from the AC outlet with
its STANDBY/ON switch in the off position.
< The apparatus should be located close
enough to the AC outlet so that you can
easily grasp the power cord plug at any
time.
< An apparatus with Class ! construction shall
be connected to an AC outlet with a
protective grounding connection.
19) Servicing — Do not attempt to service
this product yourself as opening or removing
covers may expose you to dangerous voltage
or other hazards. Refer all servicing to qualified
service personnel.
20) Damage Requiring Service — Unplug
this product from the wall outlet and refer
servicing to qualified service personnel under
the following conditions:
a ) when the power-supply cord or plug is
damaged.
b ) if liquid has been spilled, or objects have
fallen into the product.
c ) if the product has been exposed to rain or
water.
d ) if the product does not operate normally
by following the operating instructions. Adjust
only those controls that are covered by the
operating instructions as an improper
adjustment of other controls may result in
damage and will often require extensive work
by a qualified technician to restore the product
to its normal operation.
e ) if the product has been dropped or
damaged in any way.
f ) when the product exhibits a distinct change
in performance _ this indicates a need for
service.
21) Replacement Parts — When replacement
parts are required, be sure the service
technician has used replacement parts
specified by the manufacturer or have the
same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock, or other hazards.
22) Safety Check — Upon completion of any
service or repairs to this product, ask the
service technician to perform safety checks to
determine that the product is in proper
operating condition.
23) Wall or Ceiling Mounting — The
product should be mounted to a wall or ceiling
only as recommended by the manufacturer.
24) Heat — The product should be situated
away from heat sources such as radiators, heat
registers, stoves, or other products (including
amplifiers) that produce heat.