Texas Instruments 60X - Manual (Page 91)

Field Service 6-7
6.5.3 Removing/Replacing the Hard Disk Drive Assembly
The procedure for removing and replacing the Hard Disk Drive assembly is as follows:
1. Power down the notebook, disconnect the AC adapter, if installed, and remove
the battery pack as described in Paragraph 6.5.1.
2. Disconnect any peripheral device interface cables from the external interface
connectors and remove any installed PCMCIA options.
3. Turn the computer over and locate the release tab for the hard disk drive bay
cover (refer to Figure 6-4).
4. While pressing slightly on the release tab (Figure 6-4), slide the cover to the
right and set aside.
Figure 6-4 Removing the HDD Bay Cover
Release Tab
Bay Cover
Bottom of Unit