Texas Instruments 60X - Manual (Page 95)

Field Service 6-11
memory module out (refer to Figure 6-8).
6. To replace or install a DIMM module, first align the connector edge of the
memory module with the key in the connector. Insert the edge of the memory
module board into the connector using a rocking motion to fully insert the
module. Push downward on each side of the memory module until it snaps
in place.
7. Reinstall the Expansion Memory Access Cover using the screw removed in
Step 4.
Figure 6-8 Memory Expansion Removal/Replacement
NOTE: After installing expansion memory in your notebook, you must run the
PHDISK utility in order for the Save-To-Disk or 0V Suspend functions to operate
correctly (refer to the procedure in Section 2 of this manual).
Removing Expansion
Memory Installing Expansion
Memory