Trimble Outdoors AgGPS 332 - Manual (Page 56)

5 Configuring the Receiver
4 6 AgGPS 332 GPS Receiver User Guide
5.1
Introduction
Use the LCD screen to change configuration settings in the AgGPS 332
receiver. You will need to configure the receiver if you connect to
another device, for example.
• If a Trimble AgGPS Autopilot system is configured to use an
AgGPS receiver, and the port on the receiver is set to 8-N-1,
38.4 K, the Autopilot system automatically configures the
receiver.
• The EZ-Guide Plus and EZ-Steer systems require that NMEA is
set to 8-N-1, 38.4K.
Note – OmniSTAR VBS, XP, and HP are subscriber services that need to be
activated. For more information, see OmniSTAR, page 47.
5.2
Home Screen
Figure 5.1 shows the AgGPS 332 Home screen when WAAS corrections
are being received.
Figure 5.1 AgGPS 332 Home screen
D/3D í07 DOP03
WAAS 122 ÷ø04
Correction type
DGPS satellite name or ID
Signal-to-noise ratio
of DGPS satellite
Current PDOP value
Position type
Number of GPS satellites being tracked
GPS indicators
Correction
indicators