Toshiba e-STUDIO 170F - Manual (Page 179)

177
To set the e-STUDIO170F to
always print a communication
report, press:
You can request a communica-
tion report every time a docu-
ment is sent. If you desire a
communication report every
time you send a document, set
this function to ON as a default
(see page 178).
If you plan to use communica-
tion reports only occasionally,
use this procedure. The TX Re-
port key allows you to obtain a
report for one communication
only.
You can activate this option
while programming an Abbrevi-
ated Dial Number (see page
65) or One Touch Dial Key set-
ting (see page 71) if communi-
cation with a specific remote
party always requires this op-
tion.
Select the function key on the
Operation Panel.
Press:
Load the document face down
in the Document Support (see
page 82).
Adjust the resolution and con-
trast if desired (see pages 83
and 84).
Enter the number of the remote
facsimile using any of the fol-
lowing dialing methods.
• One Touch Key Dialing
... See page 89
• Abbreviated Dialing
... See page 90
• Alphabet Dialing
... See page 91
• Keypad Dialing
... See page 92
Communication Report Print
Load the Document 1 Display the TX
REPORT Menu 2 Select the Option 3 Enter the Facsimile
Number 4
JAN-31 09:43 AM 100%
AUTO RECEIVE
TX REPORT
To set the e-STUDIO170F to
only print a communication re-
port when an error condition is
encountered, press:
To set the e-STUDIO170F to
never print a communication
report, press:
3.OFF
2.ON ERROR
TX REPORT
1.ALWAYS
JAN-31 09:43 AM 80%
ENTER TEL NUMBER