Teac LPR400 - Manual (Page 25)

25
ENGLISH
Erase or Unfinalize a CD-RW
The remaining time for the operation appears in the display.
When the operation has been finished, the display returns to
the track/time display.
During erasing/unfinalizing, no buttons will work.
Never turn the power off nor unplug the power cord.
< This operation cannot be undone. If you are going to erase a
track or tracks, make sure that they are recordings that you
really want to erase.
It is possible to erase the last recorded track. It is also possible to
erase a whole disc.
Erase procedures are possible only on an unfinallized CD-RW
disc. If a CD-RW disc has been finalized, unfinalize it prior to
erasure. Remember that it is not possible to perform any erase or
unfinalize procedures on a CD-R disc.
Press the CD button to select “CD”. 1
Load a recorded CD-RW. 2
Press the FINALIZE/ERASE button in the stop mode. 3
“UnFINAL” (unfinalize) appears when a finalized disc is
loaded.
“ErASE” and the last track number appear when the disc
hasn’t been finalized.
Each time the FINALIZE/ERASE button is pressed, the display
changes as follows:
UNFINAL
Select this to unfinalize the disc.
ErASE XX (the number of the last track recorded on the disc)
Select this to erase the last track on the disc.
< This will not appear when only one track is recorded on the
disc.
ErASE ALL
Select this to erase all the tracks.
< To cancel the erasing or unfinalizing process, press the STOP
button (H).
Press the ENTER/MEMORY button to start erasing or
unfinalizing. 4
1 3
2 2 4