Toshiba M400 - Manual (Page 169)

User’s Manual 7-5
HW Setup
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set
the priority for HDD detection. If the first detected HDD has a boot
command, the system will boot from the HDD.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE] Sets PXE as the protocol (Default).
[RPL] Sets RPL as the protocol.
Built-in HDD 1 ->
Built-in HDD 2 ->
USB (Default) The priority is set as Built-in HDD 1 -> Built-in
HDD 2 -> USB.
Built-in HDD 2 ->
Built-in HDD 1 ->
USB The priority is set as Built-in HDD 2 -> Built-in
HDD 1 -> USB.
Built-in HDD 1 ->
USB -> Built-in
HDD 2 The priority is set as Built-in HDD 1 -> USB ->
Built-in HDD 2.
Built-in HDD 2 ->
USB -> Built-in
HDD 1 The priority is set as Built-in HDD 2 -> USB ->
Built-in HDD 1.
USB -> Built-in
HDD 1 -> Built-in
HDD 2 The priority is set as USB -> Built-in HDD 1 ->
Built-in HDD 2.
USB -> Built-in
HDD 2 -> Built-in
HDD 1 The priority is set as USB -> Built-in HDD 2 ->
Built-in HDD 1.
■
If a boot command is not found on the first detected HDD, the system
will not boot from the other HDD. It will search the next device in the
boot priority for a boot command.
■
Some modules may not be displayed.
Network Boot Protocol is not displayed for Gigabit Ethernet LAN.