Uniden EXAI 7248 - Manual (Page 22)

[ 2 1 ] U S I N G T H E S P E E D D I A L M E M O R Y w w w . u n i d e n . c o m
4) Enter a name according to the instructions below, then press the select/remote key. If no
name is required, go to step 5.
• The name can be up to 13 characters.
• Use the #/
→ and * /tone/ ← keys to move the cursor to the desired location.
• Use the delete/channel key to delete characters as needed.
• Press and hold the delete/channel key to delete all the characters.
Refer to the letters on the number keys to select the desired characters.
With each press of a numeric key, the displayed character appears in the following order:
Upper case letters first, lower case letters next and finally the number corresponding to
the key.
If you make a mistake while entering a name
Use the * /tone/ ← or #/ → key to move the cursor to the incorrect character.
Press the delete/channel key to erase the wrong character. Then enter the correct
character. To delete all characters, press and hold the delete/channel key.
For example, to enter Movies.
1) Press 6. Then press the #/
→ key to
move the cursor to the right.
2) Press 6 six times.
3) Press 8 six times.
4) Press 4 six times.
5) Press 3 five times.
6) Press 7 eight times.
Number of times key is pressed
keys 1 2 3 4 5 6 7 8 9
2 abc
3 def
4 ghi
5 jkl
6 mno
7 pqrs
8 tuv
9 wxyz
0
1
oper
If the next character
uses the same number
key, you must press the
#/
→ key to move the
cursor over. Otherwise
the next time you press
the number key, it
changes the character
that was previously set.
note
U
S
IN
G T
H
E SP
EED
D
IA
L
M
E
M
O
R
Y
EXAI7248.book 21 ページ ２００４年１月１５日 木曜日 午前１１時５６分