Using the remote to control dvd functions, My dvd player code is – Ultratec 43FDX10B User Manual
Page 30
30
USING THE REMOTE TO CONTROL DVD FUNCTIONS
Operating the precoded function for your DVD player.
This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of
your DVD player. (refer to page 32 for pre-codes)
1.
Turn ON your DVD player.
2.
Aim the remote control at the front of your DVD player.
3.
Press and release the DVD button to switch to DVD pre-coded mode.
4.
Hold down the DVD button on the remote and enter the two digit preset code that matches your DVD player, as shown on page 32.
The indicator light will flash 3 times if the code was accepted.
5.
Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two
digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not
turn off, try a different two digit preset code.
6.
The remote will now control your DVD player.
NOTES:
1.
If your DVD player cannot be operated after performing
the above procedures, your DVD playerÕs code has not
been precoded into the remote.
2.
In the unlikely event that your DVD player cannot be
operated after performing the above procedures, please
consult your DVD player operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
ቢ
DVD Button
This button allows the remote to control your DVD player by
setting it to DVD mode.
ባ
PRECODED DVD Buttons
These buttons transmit the chosen precoded DVD codes.
ቤ
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
POWER
TV
VCR
CBL
DVD
1
2
4
5
6
3
7
8
9
0
LAST CH
SLEEP
HELP
EXIT
MENU
CH
VOL
MUTE
PIP
PIP CH
SWAP
FREEZE
PIP MODE
PIP ACCESS
PROG
TV/VCR
SLOW
SOURCE WIZARD
REC
SELECT
ቢ
ባ
ቤ
ቤ
ባ
ቤ
C.C.
ASPECT
STB
ANT
STATUS
INFO
VCR PLUS+
SVCS
GUIDE/TV
SCHD
VID 1
VID 2
VID 3
VID 4
VID 5
AV2
AV1
AV3
PIX
CLU-5711TSI
POWER
TV
VCR
CBL
DVD
1
2
4
5
6
3
7
8
9
0
LAST CH
SLEEP
HELP
EXIT
MENU
CH
VOL
MUTE
PIP
PIP CH
SWAP
FREEZE
PIP MODE
PIP ACCESS
PROG
TV/VCR
SLOW
SOURCE WIZARD
REC
SELECT
ቢ
ባ
ቤ
ቤ
ባ
ቤ
C.C.
ASPECT
STB
ANT
STATUS
INFO
VCR PLUS+
SVCS
GUIDE/TV
SCHD
VID 1
VID 2
VID 3
VID 4
VID 5
TAPE
CD
AMP
MODE
CLU-5713TSI
MY DVD PLAYER CODE IS:
NOTE:
Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.