UMAX Technologies Mirage II - Manual (Page 6)

vi
Note: If you already have a SCSI card installed on your computer:
When installing the software, you will be asked to choose TYPICAL or
CUSTOM installation. Choose CUSTOM and select “Adaptec or other ASPI
Compatible Interface Card” when installing the scanner driver. Otherwise, the
scanner will not work properly.
5. Connecting the SCSI Cable
Connect the SCSI cable to the SCSI interface card and the other end of the SCSI
cable to the scanner.
If your scanner is not chained to other SCSI devices or at the end of the SCSI chain,
please connect the terminator to the remaining SCSI port of your scanner.
6. Connecting the Power
Connect the appropriate end of the power cord to the scanner and the other end to a
grounded power outlet. When you turn the scanner on, it will automatically perform
a power-on selftest. When the selftest is completed, the power and ready indicators
glow steadily .
7. Powering Up
a) Turn the scanner power switch on. When the Ready indicator is on, your
scanner is ready to use.
b) Turn on your computer.
To an outlet
Connect the SCSI Cable
Power Switch