Uniden BC250D User Manual
Page 53
Programming and
Receiving
Digital and Trunked
Systems
There are three steps for programming a trunked sytem:
1. Program the Trunk Type – What type of system will the
scanner be tracking, Motorola Type II, Type I, EDACS,
LTR, etc.
2. Program the Trunked Frequencies – Within a trunked
system, the frequencies are shared among all the users,
called “Talk Groups”.
• Within the bank you decide which channels to program
the trunked frequencies.
3. Program the Talk Groups – Within the trunked system,
each agency or department is assigned a Talk Group ID.
This ID must be programmed into the scanner in order to
monitor that specific agency or department.
• When programming you decide which “Location” to
program the “Talk Groups”. This is similar to how you
program frequencies into channels. Here you need to
program Talk Group ID’s into Locations.
STEP 1:
Selecting or Changing Trunking System Type
Before using the Trunk Tracking system, you must select the
bank and trunk type. You can only track one trunked system
per bank, total of 10 trunked systems.
1
Press MENU/BACK.
☞ Remember! You can also enter the
Trunk Tracking Programming mode by
pressing TRUNK.
2. Select 2:SCAN OPTION /
2:TRUNK by rotating the VFO and
pressing E.
3
Select the bank number using the
keypad or the VFO and pressing E.
4. Select 1:TRUNK TYPE / 1:ON- and the system type
you want to track by rotating the VFO and pressing E.
For Type 1 System, you must enter the block and fleet
numbers. Please refer to “Programming a Fleet Map” on page
49
C 001
OOOO.0000
1:TRUNK TYPE
2:TRUNK CHANNEL
C 001
OOOO.0000
1:TYPE2 800
2:TYPE1
BC250D 11/6/2 11:37 AM Page 49