Ultra electronic MAGICARD 300plus - Manual (Page 14)

Quick Start Guide Ultra Electronics Card Systems
Page 14 MAGICARD Color Printer
Locate the Mains Voltage Selector
Switch on the rear panel and check that it
is correct for your country - select 115V
or 230V.
Plug in the Power Cord. Plug the other
end into a Power Supply socket.
Locate the ON/OFF Switch and check
that it is in the OFF position.
Switch ON. The indicators should all
flash and the motors run briefly. Finally,
the POWER ON and ON LINE will remain
ON.
Connect the Printer
to a Power Supply
F
1
3
2
4