U-Line Refrigerator/Ice-Maker Combos - Manual (Page 18)

16
User’s Manual
12. Adjust door to assure proper seal. Tighten upper hinge screws
securely.
13. Replace three plastic plugs removed in step 8 into holes on top of
unit. Replace screws in holes in bottom of unit, opposite side.
14. Reinspect door seal and alignment. Adjust if needed.
15. Reinstall grille (1 screw).
NOTE
On Combo Model 75A (built-in installations only), changing
the door mounting to the left side may interfere with ice
bucket removal. See BUILT-IN INSTALLATION section for
clearance requirements.
To reverse the door mounting on Models Combo 75A and 75R
(except Stainless Steel models) perform the following:
1. Remove grille (1 screw). See Figure 15.
2. Remove top hinge from cabinet (4 screws). See Figure 16. Hold
door to keep it from falling.
3. Lift the door off the bottom hinge.
4. Remove four plastic plugs in hinge holes, top of cabinet, opposite
side (see Figure 22). Be careful not to scratch cabinet.
5. Remove pivot screw from top
hinge, invert screw and rein-
stall pivot screw in top hinge.
See Figure 21. Do not install
hinge on cabinet at this time.
6. Remove bottom hinge from
cabinet (4 screws) and
screws on opposite side of
cabinet (see Figure 24).
7. Remove pivot screw from
bottom hinge, invert screw
and reinstall pivot screw in
hinge (see Figure 21).
UL128
Figure 24
Users Manual 41923 9/2/03 3:44 PM Page 16