U-Line Refrigerator/Ice-Maker Combos - Manual (Page 25)

23
INITIAL START-UP
Once installation is complete, the unit is ready for initial start-up and
operation.
NOTE
Models BI-95 and BI-98
have the ON-OFF switch
behind the front grille. A
small opening in the top
of the grille is provided
to access the switch
(see Figure 34).
Some models may also turn
off when the temperature con-
trol is turned all the way
towards warmer until it stops
(clicks).
1. Plug the appliance cord into a 115V polarized and grounded
electrical outlet.
2. Check that the ON-OFF switch in the ON position.
3. Open the water supply valve in the main water source. As soon as
the ice maker mold reaches the proper temperature, the ice
maker mechanism will fill the mold with water. The first cubes may
be small because of air in the water line. Subsequent cubes will be
of standard size. Approximate time for the first cycle is 45
minutes. Allow 2 hours for any Frostfree models.
It is possible that dirt or scale will dislodge in the water line.
Always throw away all ice cubes made during the first two
to three hours of operation.
Allow unit temperature to stabilize for 24 hours before use.
UL503
Figure 34
Users Manual 41923 9/2/03 3:44 PM Page 23