Built-in installation – U-Line Refrigerator/Ice-Maker Combos User Manual
Page 23
21
NOTE
Use care not to bend light switch bracket (where installed),
located on door bottom when installing door insert. Do not
set door on bottom edge when pushing insert into place.
6. Slide custom door panel insert into 1/4 inch channel in door front.
7. Holding door gasket out of the way, replace handle on door mak-
ing sure it is seated properly on insert and that screw holes line
up.
8. Install two small screws removed in step 4.
9
Starting at the center and working outward, push door gasket into
place on door.
10. Place door on bottom hinge pin and install upper hinge screw (see
Figure 28).
11. Reinspect door seal and alignment. Adjust if needed.
BUILT-IN INSTALLATION
Your U-Line product has been designed for either free-standing or built-
in installation. When built-in, your U-Line product does not require addi-
tional air space for top, sides, or rear. However, the front grille must
NOT be obstructed.
NOTE
Combo Models 29A, 29FF, and 75A require additional
clearance when the door opens from the right (see Figures
32 and 33). This additional clearance allows for the ice
bucket to be removed from the unit.
Unit Dimensions
Model
Width
Height
Depth
SP18
13-15/16"
18-1/2"
25-1/4"
95
13-13/16"
24-3/4"
17"
98
14-13/16"
27-3/8"
20"
15 Series
14-15/16"
34 - 35"
23-3/4"
29 Series
20-13/16"
28-1/2"
24"
75 Series
23-7/8"
34 - 35"
24"
Users Manual 41923 9/2/03 3:44 PM Page 21