Vision Fitness ST730 - Manual (Page 14)

14
6
STEP
• Remove pulley M and one of the rollers
(GO9) in the front of the upright frame
(AG1). Guide the bolt end of cable #2
(F18) through the hole, routing towards the
rear in upright frame (AG1), and reinstall
roller (G09) and pulley M for the cable to
wrap around (bottom). Remove the bottom
pulley (L) on the floating tri-pulley (AF1),
place the cable (F18) inside, and reinstall
pulley. Guide the cable back down
towards the pulley bracket in the upright
frame, and thread the cable bolt into the
hole behind pulley M, making sure the
bolt is threaded in as far as possible
(0.5” minimum). Tighten the nut to the
connection point.
CABLE #2
L
M
G09
F18
AG1
AF1