Vision Fitness ST730 - Manual (Page 15)

15
Q03 Q03
Q02 Q02
Q01 Q01
B09 B09
B11 B11
Q05
Q06
Q04
AC2
C09
7
STEP
• Loosely attach each of the two shield
mounting brackets (B11) to the underside
of the overhead lat arm (AC2) with two
bolts (M5x10), two lock washers
(5.1x9.3x1.3), and two flat washers
(5.3x10x1)
• Align holes in rear shield (QO3) with
the holes in the brackets (BO9 & B11) on
the back side of the weight stack; loosely
secure using 8 bolts (M5x10). Take the left
(QO1) and right (QO2) side shields and
repeat on front side of weight stack tower
using five bolts (M5x10) for each shield.
Tighten all bolts.
• Loosely mount the left (QO5) and right
(QO6) covers to the brackets (C09) on the
overhead lat arm (AC2) using three bolts
(M5x10) and three flat washers
(5.3x10x1) on each shield. Place the front
shield (QO4) on front and mount using
eight bolts (M5x10) and eight flat washers
(5.3x10x1). The center holes on each side
need a flat washer (5.3x10x1) and a nut
(M5) attached on the inside of the shield.
Tighten all bolts.
BLACK BAG