Visioneer DP1011 - Manual (Page 14)

Xerox DP1011 User’s Guide 9
Installation
To turn off the projector power
1. Press the Power button on the projector or Remote Control to
turn off the projector lamp.
An on-screen message appears: Power off the lamp?
2. Press the Power button again to confirm.
If you don’t press the button again within five seconds, the
message disappears and the lamp remains lit. This convenient
design is in case you accidently press the Power button in the
middle of a show and do not want to turn off the projector.
If you do press the Power button a second time, the
Power/Standby indicator flashes
orange for about 40 seconds.
Then the projector automatically shuts itself down.
3. To turn on the projector again, press the Power button within
40 seconds of the indicator flashing.
4. Disconnect the power cord.
Warning Indicator Lights
• If the Warning indicator turns red , the projector has overheated.
The projector will automatically shut itself down.
• A Warning indicator flashing red (0.5 second intervals),
indicates a problem with the lamp. Turn off the projector and
disconnect the power cord from the electrical outlet, then
contact your local dealer or our service center.
• A Warning indicator flashing red (1 second intervals), indicates
an internal problem. Turn off the projector and disconnect the
power cord from the electrical outlet, then contact your local
dealer or our service center.
• A Warning indicator flashing orange , indicates high-speed
cooling in progress. This is not an abnormal condition, and you
can continue using the projector.
NOTE: Do not turn off the projector immediately following a
power off procedure. Let it cool down first.
Warning Indicator