Visioneer DP1011 - Manual (Page 7)

Xerox DP1011 User’s Guide 2
Precautions
Precautions
Follow all warnings, precautions and maintenance as
recommended in this user’s guide to avoid injury and to maximize
the life of your projector.
Warning—Do not look into the projector’s lens when the lamp is
on. The bright light may hurt your eyes.
Warning—To reduce the risk of fire or electric shock, do not
expose this product to rain or moisture.
Warning—Do not open or disassemble the product as this may
cause electric shock.
Warning—When changing the lamp, please allow unit to cool
down, and follow all changing instructions.
Warning—This product will detect the life of the lamp itself. Please
be sure to change the lamp when it shows warning messages.
Warning—Reset the “Reset Lamp Hours” function from the On
Screen Display “Management” menu after replacing the lamp
module (refer to “Projector Management” on page 19).
Warning—When switching the projector off, please ensure the
projector completes its cooling cycle before disconnecting power.
Warning—Turn on the projector first and then the signal sources.
Warning—When the lamp reaches the end of its life, it will burn out
and may make a loud popping sound. If this happens, the projector
will not turn back on until the lamp module has been replaced. To
replace the lamp, follow the procedures in “Changing the Lamp” on
page 21.