Vincent Audio SV-123 - Manual (Page 14)

Vincent 27 26 Vincent
10. 75Ω FM ANTENNA:
VHF antenna socket:
Connect a coaxial antenna cable here for FM
radio reception. If there is no antenna wall
socket, a room antenna or the wire antenna
supplied can be used.
11. LOOP ANTENNA:
Socket for the loop antenna
Connect the loop antenna supplied or an
outside antenna here if you require medium
wave reception.
12. SPEAKER:
Loudspeaker terminals
Output sockets with screw contacts to connect
a pair of stereo loudspeakers. Loudspeaker
cables with 4 mm banana plugs can be used.
13. INPUTS:
Terminal panel for stereo audio
signals of source equipment
Five stereo cinch input sockets for source
equipment with analogue stereo audio output.
14. OUTPUT “REC”:
Recording output
The stereo signal emitted from this output is
identical to the input signal of the source
currently selected. If required, connect a
recording device here for example.
15. OUTPUT “PRE”:
Preamplifier outputs for
stereo channels
Enables the preamplified stereo audio signal
from the source currently selected to be fed to
two additional amplifier channels.
16. Fuse holder
small, round plastic casing contains the
appliance's fuse. Take note of the safety
information regarding this.
17. Power socket
Introduce the power cable here and connect it
with the power supply.
REAR VIEW:
14 13 15 16 17
10 11 12
Point the front of the remote control directly at the
front of the appliance, making sure there are no ob-
jects between the remote control and the appliance.
The distance between the remote control and the
appliance should not be more than 7m, as the
reliability of the remote control is affected beyond
Only use AA (LR6) size batteries.
REMOTE CONTROL
Changing/inserting batteries:
a. Open and remove the battery compartment
cover on the remote control by sliding the
cover on the underneath in the direction of
the arrow marked on it and then lifting it off.
b. If necessary, remove used batteries and insert
new ones correctly as shown by the diagram
in the battery compartment.
c. Put the compartment cover back on and close
the battery compartment.
BATTERIES
this range. Make sure that you do not point the
remote control at an angle to the appliance, as
beyond an angle of ±30° to the centre axis the
appliance may not respond as well to the remote
control. Change both batteries if the distance at
which the remote control can be used effectively
decreases.
Using batteries
Handling batteries incorrectly can cause battery
acid to escape or an explosion in extreme cases.
The batteries must be correctly inserted taking note
of the polarity, which is marked in the inside of the
battery compartment. In order to make full use of
the batteries' life, do not mix new and used batte-
ries. Make sure that you insert batteries of the
same type. Some batteries are rechargeable,
others are not however. Take note of the precauti-
ons and instructions that are included on all batte-
ries. Remove the batteries if the remote control is
not going to be used for a long time. Under no cir-
cumstances must batteries be short-circuited, taken
apart or heated up. For environmental reasons,
used batteries should be disposed of in accordan-
ce with local environmental regulations and not put
with domestic waste.
old
new
b
a
c
SV-123_komplett 2 02.02.2007 8:51 Uhr Seite 26