Vincent Audio SV-123 - Manual (Page 17)

Vincent 33 32 Vincent
Check whether the wall socket provides the appro-
priate mains power, which is the case if it is sup-
plied with 230 V AC 50 Hz. Push the plug for
non-heating appliances on the power cable sup-
Take note of the correct polarity: the positive contact
is usually red and often marked with “+”. The mar-
ked lead on the loudspeaker cable must be connec-
ted to the positive terminal. If you are using ready
made loudspeaker cables with plugs, all you need
do is connect the two plugs on each loudspeaker
cable to the two terminals that belong to them. Otherwise strip about a 1cm long piece from the
insulation on each end of the loudspeaker wire. Twist
the bare wire to prevent short-circuits. Turn the knob
on the loudspeaker terminal anti-clockwise to loosen
it and introduce the bare wire end into the open ter-
minal hole. Then turn the knob clockwise to fasten the
wire tightly in the loudspeaker terminal.
CONNECTING THE LOUDSPEAKERS
CONNECTING A RECORDING DEVICE
STEREO PREAMPLIFIER OUTPUT
If you want you can use the “REC” cinch sockets (14)
on the back of the appliance to connect an analogue
stereo recording device (e.g. CD recorder, cassette
recorder, video recorder) or another appliance that is
intended for receiving the unchanged, set stereo output
level (line level) from the signal source selected on the receiver at any given time. The output level is indepen-
dent from the volume, loudness and mute functions.
To do so, connect this signal output to the signal input
(RECORD or INPUT) on the appliance using cinch
cables.
You only need the “PRE” sockets (15) if you want to
use a separate stereo amplifier or two mono ampli-
fiers to supply two additional loudspeakers.
This makes sense if you intend to use two more loud- speakers for stereo music playback, perhaps even in
another area. These loudspeakers are then connec-
ted to the outputs of the additional amplifier.
CONNECTING THE POWER CABLE
CONNECTING HEADPHONES
plied firmly into the power socket (23) on the back
of the appliance. Plug the other end of the power
cable into a mains socket.
A set of headphones equipped with a 6.3 mm
jack can be plugged into the “PHONES” socket
(9) on the front of the appliance. When this hap-
pens, the system's loudspeakers and the “PRE” preamplifier output (15) are muted. The volume
should be turned down before plugging in or
unplugging. All headphones with an impedance of at
least 32 Ohms can be used.
SV-123
loudspeaker
connection
RCA connection
SV-123
recording device: CD-Recorder,
Tape etc.
1
LINE-IN
SV-123
separate
Stereo amplifier
1
INPUT
SV-123_komplett 2 02.02.2007 8:51 Uhr Seite 32