Vinotemp VVTT--FFUULLLLKKEEGG - Manual (Page 6)

6
W W W . V I N O T E M P . C O M
INSTALLATION INSTRUCTIONS
Before Using Your Beer Dispenser
• Remove all exterior and interior packing materials. This includes foam base and any
adhesive tape holding accessories both inside and outside the unit.
• Check to be sure you have all o the following parts:
• 1 Instruction manual
• 1 Safety Guard Rail
• 1 Drip Tray (2 Pieces)
• 1 CO
2
Cylinder Holder
• 1 CO
2
Regulator (Box)
• 1 CO
2
Empty Cylinder (Box)
• 1 CO
2
Air Line Hose (Red)
• 2 CO
2
Hose Connectors
• 1 Beer Keg Coupler (Box)
• 1 Beer Tower Assembly
• 1 Pull Handle (Beer Tower Faucet)
• 1 Metal Wrench
• 4 Plugs (For Guard Rail Holes)
• 1 Metal Plate for Cabinet Bottom
• 2 Steel Wire Shelves
• 1 Steel Clamp for Red Hose
• 1 Beer Tower Top Plastic Cover
• 4 Castors with Lock
• Before connecting the Beer Dispenser to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Beer Dispenser
• This appliance is designed to be free standing only, and should not be recessed or
built-in.
• Place your kegerator on a dry, flat surface that is strong enough to support the
beer dispenser when it is fully loaded.
• Allow 3 inches of space between the back and sides of the beer dispenser, which
allows proper air circulation to cool the compressor and condenser.
• Locate the beer dispenser away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient temperatures
may also cause the beer dispenser not to perform properly. This unit is not
designed for outdoor installation (i.e. garages, porches, etc.)
• Avoid locating the Beer Dispenser in moist areas.
• Plug the beer dispenser into an exclusive, properly installed-grounded wall outlet.
Do not under any circumstances cut or remove the third (ground) prong from the
power cord. Any questions concerning power and or grounding should be directed
toward a certified electrician or an authorized Vinotemp service technician.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3
hours before placing any contents in the beer dispenser compartment.
Reversing the Door Swing of Your Appliance
z
This appliance has the capability of the door opening from either the left or right
side. The unit is delivered to you with the door opening from the left side. Should
you desire to reverse the opening direction, please see below instructions:
1. Be very careful when tilting appliance to side to get bottom door hinge.
2. Undo the three screws in each bracket using a Philips screwdriver (not
included).
3. Remove the screws and bracket from cabinet and set aside for later use.
4. Slide the fridge door down about 6” and off the top hinge pin. Lift away from
cabinet body.
5. Using a flathead screwdriver (not included), remove the pin from the top
bracket. Replace it in the hinge bracket on the opposite side.
6. Remove the screw from the bottom of the fridge door on the side where bracket
is to be re-fitted and replace on other side of door (where bracket was