Vinotemp VVTT--FFUULLLLKKEEGG - Manual (Page 7)

7 1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
previously removed from).
7. Carefully slide the fridge door back on to the top hinge, making sure it’s the
right way up. Screw the bottom hinge into place on the new side.
8. Check that door is aligned horizontally and vertically and that the seals are
closed on all sides before finally tightening the bottom hinge. Re-adjust the
leveling feet as needed.
9. If cooler has been on its side or tilted, always wait several hours before
reconnecting to power source to allow the refrigerants to settle.
Installing the Castors
z
Remove the 4 castors from one of the boxes inside the unit. Install the two castors
with metal bracket at the front designated positions of the cabinet base and the
additional two castors at the rear-designated positions (Four screw holes are pre-
supplied).
z In order to release or lock the brake, follow the below guide.
Step d own to Br ake Step on to Release Brake
Kegerator Assembly
• Place the gasket over the hole opening on
the worktop.
• Pass both the wing nut and the beer tube
through the hole on the worktop until the
beer tap is resting on top of the cabinet.
• Revolve the beer tap clockwise and secure it.
• Spanner faucet wrench provided for either
removing or tightening connection.
• Attach the black plastic lever (pull handle)
provided on the top of the faucet tightening
it by hand clockwise until the end, holding i
the silver snug underneath so it does not
move. (See Figure 1)
n