Vinotemp VVTT--FFUULLLLKKEEGG - Manual (Page 9)

9 1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
BEER KEG SETUP
Installation Of the Keg Coupler
• Insert the keg coupler provided into the locking
neck of the beer keg and turn it clockwise to lock
into position, making sure the keg coupler is in
the closed position. (See Figure 3)
Figure 3
Installation of the CO
2
Air Line Hose
• Attach the end of the red hose provided to the hose connection on the keg coupler.
Secure hose by using the connector and make sure there are no leaks.
Installation of Protective Metal Plate
• This plate should always be installed when the keg is in place to protect against
unnecessary damage to the floor of the cabinet liner.
Installation of the Beer Keg
• Position the beer keg directly in front of the open door. Using keg handles only,
carefully lift the beer keg. (See Figure 4)
• To place the beer keg inside the cabinet, brace your knees behind the beer keg. Lift
the front of the keg just enough so the front edge of the keg is resting on the front
edge of the Beer Dispenser bottom cabinet. (See Figure 5)
• Grasp the keg handles and slide it all the way into the cabinet.
Figure 4 Figure 5
NOTICE: THE BEER TOWER ASSEMBLY OF YOUR UNIT COMES WITH A FLAT MYLAR
WASHER. YOUR UNIT MAY NOT REQUIRE THE USE OF THIS WASHER AS TOWER IS
DESIGNED FOR A TIGHT AND SECURE FIT. HOWEVER, WHILE INSTALLING THE TOWER
TO THE UNIT THIS WASHER CAN BE USED FOR A TIGHTER FIT IF NECESSARY.