VocoPro DA-8909RV - Manual (Page 15)

13
1. POWER - This remote control button turns the DA-
8909RV ON/OFF
2. INPUT SELECTOR - These buttons switch between the
signals from CD, CDG, AUX and DVD inputs. Whicever
player or source music is connected to these respective
AUDIO INPUTS will be activated with these keys.
3. MIC VOLUME - Use the  to raise the MIC MASTER
VOLUME (front panel, #5) and the  to lower this mixed
MIC MASTER VOLUME. You will see the controls on the
DA-8909RV move as you make adjustments using the
remote keys.
4. MUSIC VOLUME - Use the  to raise the MUSIC VOLUME
(front panel, #6) and the  to lower the MUSIC VOLUME.
You will see the controls on the DA-8909RV move as you
make adjustments using the remote keys.
5. VOCAL CANCEL/VOCAL PARTNER - With Multiplex
media, lead vocals and music are recorded in separate left and right stereo channels. When the VOCAL
CANCEL (VOC/C) button on the remote is selected, the LED will illuminate and the lead vocal channel
will be removed, leaving a duplicated instrumental track to left and right only. When VOCAL PARTNER
(VOC/P) is pressed, the LED will illuminate and the vocal track will only be activated only while there is
no microphone input. In other words, while the Karaoke singer is performing, the vocals will never drop
entirely out, keeping the action going.
6. DIGITAL KEY CONTROL - You can adjust the key of your source music in half-step increments to match
the natural range of your voice using the KEY CONTROL buttons on the remote control. To flat (b) or
lower the key, press the left KEY CONTROL button. To sharp (#) or raise the key, press the right button.
To return to the original key of the music input source, press the center button. You will see the DIGITAL
KEY DISPLAY reflect the number of steps you have increased or decreased displayed as numerals with
+/-, or 0 for the original key.
The maximum operating distance between the Remote Control and the REMOTE SENSOR is approxi-
mately 23 feet. If the effective distance of the Remote decreases, replace the batteries. To install new
batteries, remove the battery compartment lid on the back of the Remote and insert two AAA batter-
ies with polarities aligned.
Remote Control Descriptions and Functions
2
1
3
4
5
6
�������