VocoPro DTX-9909K - Manual (Page 12)

12
Connecting Speakers
The Speaker Terminals are located on the rear panel. There
are two FRONT terminals, one CENTER terminal, Two SUR-
ROUND terminals and two SURR BACK (surround back)
terminals. Be sure to connect the left channel (L), right
channel (R), “+” (red) and “--” (black) properly.
���������
������
�������������
��������������
���������
��������
����������������������������
��
� � �
��������������������
Caution
• If using 4 Ω speakers, be sure to set the DTX-
9909K’s speaker impedance setting to 4 Ω before
using. If using 8 Ω speakers, make sure it is set to
8 Ω . The speaker impedance switch is located on
the rear panel.
���������
������
�������������
��������������
���������
��������
����������������������������
��
��������
�� ��
������������������
��� � � �
� � � �
� � �
� � �
�
� � �
���������
������
• Before connecting the speakers, make sure that the DTX-
9909K is disconnected from the power source.
• Do not let the bare speaker wires touch each other or
another metal part of this unit. This could damage the
DTX-9909K and/or the speakers.
Preparing the Speaker Cable
You can either used an exposed speaker wire or Banana
Plug speaker cable.
Exposed Speaker Wire
1. Remove approximately 3/8” (10mm) of insulation
����
2. Twist the exposed wires together to prevent short circuits
4. Insert the bare wire
5. Tighten the knob until the wire is secure
� � �
����������������
Getting Connected