VocoPro DTX-9909K - Manual (Page 35)

35
The DTX-9909K has a built-in AM and FM tuner that allows
you to listen to your favorite radio stations
Connecting the Antennas
The antennas must be connected in order to receive clear
reception.
Indoor FM Antenna
1. Connect the FM loop antenna, with the coaxial end, to the
FM COAX. jack on the rear panel.
2. If necessary, hang the other end of the antenna so that it
is up higher and out of the way of any hindrance.
Indoor FM antenna
(included)
AM Loop Antenna
1. Uncoil the antenna wire
2. Press down on the antenna tab to open the terminal
3. Insert the exposed wires
4. For best reception, rotate the antenna horizontally
AM loop antenna
(included)
Operating the Auto Tuner
1. Press the TUNER AUTO button on the remote control or
INPUT button on the front panel to select TUNER as the
input source
2. Press the TUNER AUTO button on the remote control to
select AM or FM
There are two ways to tune: automatic and manual. Auto-
matic tuning is effective when station signals are strong and
there is no interference. If the signal from the station that
you want to select is weak, you must tune it manually.
Manual Tuning
1. Press the SCAN + or SCAN -- buttons on the remote con-
trol to find your desired station.
2. You can also press and hold the SCAN + or SCAN -- but-
tons for about one second to use the automatic search
function. Automatic search will automatically scan up or
down until it finds a clear station.
AM/FM Tuner Operations