Viking InterWorks 56K - Manual (Page 9)

VIKING COMPONENTS 56K USB MODEM USER’S GUIDE
Software Installation
Once the Viking USB fax/modem is installed, you will need to install the software
necessary to communicate with the fax/modem. This section will cover the steps
necessary to configure your computer’s operating system. Please proceed to the
following pages for your computer’s operating system:
• Windows 95 (OSR2) page 7
• Windows 98 page 9
Windows 95 (OSR2) Software
1. You will be prompted with the “New Hardware Found” message. Click on the
“OK” button.
2. The “Update Device Wizard” win-
dow will appear. The device found
should read: “Unknown Device.”
With the “Viking USB Modem
Installation Disk” still in the floppy
drive, click on the “Next” button.
Note: If the diskette can not be
located, the drivers can be down-
loaded from our Web site at:
www.vikingcomponents.com
3.Your system will retrieve the nec-
essary drives off the driver diskette.
Note that the “Device Found” has
changed from “Unknown Device” to
the “Viking USB Modem Board.”
Then click on the “Finish” button.
Chapter 3 7