VBrick Systems Portal Server ETV v4.1 - Manual (Page 52)

42 © 2007 VBrick Systems, Inc.
to http://innotechsystems.com/Spitfire/SpitFire III.pdf Be aware that the device codes at
this link are not tested or supported by VBrick. If you can't find the code you need, or have
trouble controlling a non-supported device, check the product documentation or contact the
manufacturer.
Connecting Control Devices
To set up a device that can be remotely controlled from the Portal Server, you connect the
serial interface on the source device (the DVD or VCR) to the passthrough port (COM1 or
COM2 for Slots 1 and 2 respectively) on the VBrick encoder using an appropriate cable (see
Table 10) from those shipped with the encoder. For more about Serial Port Passthrough, see
the online help for the encoder. You can also control devices using VBrick's VBIR remote
controller. To use the VBIR remote controller, you connect the VBIR SpitFire device to
COM1 or COM2 on the VBrick encoder. The VBIR subsequently communicates with the
DVD or VCR via infrared commands (see Figure 8) at the configured baud rate.
If necessary, connect one end of the XIR emitter cable to the SpitFire and the other to the
DVD or VCR making sure the adhesive lead is securely attached to the device. The emitter is
used when there is no direct line-of-sight to a control device (for example when the VCR is in
a cabinet) and you can't use the remote control. On the back of the VBIR, be sure the
SpitFire is in RS-232 mode.
Note The VBIR (SpitFire III model only) can also "learn" (i.e. be programmed to use) IR
commands much like a universal remote controller. Learned commands are stored in
VBIR memory areas called slots and are accessed by reserved three-digit codes. The
six slots are available are: AUX (994), TV (995), VCR (996), DVD (997), AUD (998),
and CBL/SAT (999). For a detailed explanation of how a VBIR "learns" commands,
see the Application Note Learning IR Commands on the VBIR on the VBrick
Product Documentation website.