VBrick Systems Portal Server ETV v4.1 - Manual (Page 68)

58 © 2007 VBrick Systems, Inc.
4. Configure
Advanced Settings
for VBricks and STBs as necessary. As noted, it is unlikely
you will ever need to change these settings. In all cases you can safely ignore these
settings and use the defaults provided by the Portal Server.
These settings generally set configuration options for source devices and destination
devices (VBricks and STBs) so that they are configured properly (e.g. transmit/receive
enabled/disabled) at the beginning and end of an emergency broadcast. All required
devices must be present and enabled for a successful emergency broadcast. The settings
differ depending on the device (e.g. MPEG-1, MPEG-2 or MPEG-4) you select and may
include some or all of the fields explained below.
Note
Advanced Settings
are available to configure VBricks and STBs with exceptional
configuration parameters. It is unlikely you will ever need to change these settings. In
all cases you can safely ignore the
Advanced Settings
and use the defaults provided
by ETV Portal Server.
Template name Alphanumeric characters or spaces. No special characters.
Schedule Type Live Broadcast
• VBrick – Select a live stream by VBrick Name. Then select the
destination VBricks or STBs.
• Program Name – Select a live stream by Program Name from all
available. Then select the destination STBs.
• Enter Manually – Select an MPEG source residing at a specified IP
address. Then select the destination STBs.
Stored Broadcast
• VoD Name – Select a VOD server and a source video. Then select
the destination VBricks or STBs.
• VBrick Name – Select a VBrick (or VBStar) and a source video.
Then select the destination VBricks or STBs.