Vision Fitness T8600S - Manual (Page 18)

16
upright & semi-r ecumbent
E 3 6 0 0 H R C
R 2 6 0 0 H R C
TROUBLESHOOTING YOUR FITNESS BIKE
Our Bikes are designed to be reliable and easy to use. If, however,
you have a problem, these troubleshooting steps may indicate the
cause.
PROBLEM: The Console does not light up.
SOLUTION: 1) Check to make sure the Bike is turned on (switch is
located near power supply).
2) If you are using the Bike without a power supply, be sure you are
pedaling fast enough to power the Console. If the problem persists,
plug in the power supply, turn the Bike on and test to see if the
Console powers up.
PROBLEM: The Bike is making a
clicking noise.
SOLUTION: Using the supplied
15
MM wrench, remove both the
right and left pedals, apply
grease to the threaded portion of
the pedals and reassemble the
unit, making sure the pedals are
as tight as possible.
PROBLEM: The Bike appears to work but there is no resistance
change.
SOLUTION: The magnetic brake assembly is not working
properly; please contact your retailer.
PROBLEM: The Bike makes a squeaking or creaking noise.
SOLUTION: Check and tighten all the bolts on the Bike again.
NOTE: If the above steps do not remedy the problem, discontinue
use, turn the power off and contact your retailer.