Set digital outputs, Erase snapshots stored in flash memory, Erase logo and graphic buttons – Vivotek IP3111/IP3121 User Manual
Page 74: Skip installation during the next boot, Reset network for new settings, Restore factory default settings, Reset system
www.vivotek.com
T:
886-2-22404099
F:
886-2-22404097
73
Set digital outputs
To set digital output to connect NO with COMMON, type "DO=L".
To set digital output to connect NC with COMMON, type "DO=H".
Erase snapshots stored in Flash memory
Typing "erase image" will clear all snapshots saved in Flash.memory.
Erase logo and graphic buttons
Typing "erase graph" will clear all images used on the homepage. If no new images are uploaded, the
system will switch to text mode and use default images instead.
Skip installation during the next boot
Typing "lock" will inform NetworKam to fix current network settings. It need not wait for installation
during the next boot.
Reset network for new settings
Typing "unlock" will make NetworKam give up current settings and wait for installation.
Restore factory default settings
Typing "clear" will make NetworKam restore factory settings but not restart. To validate new settings,
type "reset" to make the system restart.
Reset system
Typing "reset" will make NetworKam perform a software reset.