Vision Fitness T9700 - Manual (Page 6)

6
3
STEP
2
STEP
2
STEP
• Mount the console to the console
mast using four bolts (M8 x 15L) and
tighten with the 5mm Allen wrench.
NOTE: Push all extra data cable into
the console mast. Make sure not to
pinch or cut the data cable.
• Mount the right-hand side mount
handlebar to the console mast using
two bolts (M8 x 135L). Repeat this on
the left-hand side.
BLUE BAG
3
STEP
MODELS T9200, T9300HRT,
T9500HRT, T9500HRT Ortho, &
T9600HRT Comfort: Plug in the small
data cable into the small plug
connection on the lower control
board. Plug in the large data cable
into the large plug connection on the
lower control board. Slide down the
rubber covers on the left & right
console supports.
MODELS T9700S, T9700HRT: Plug
the large 20-ribbon cable into the
20-pin connection on the lower
control board. Slide down the rubber
covers on the left & right console
supports.
• Install the motor cover making sure
that the rubber covers are inserted into
the motor cover. Secure the motor
cover using the six (M4 x 12L) screws
(see Yellow bag).
DATA CABLES