Vogelzang International PB65XL - Manual (Page 6)

Page 6 / PB65XL Vogelzang International Corp. VGZ-003 / 20120327.0
CONNECTOR PIPE INSTALLATION
1. The smooth end of the stovepipe fits over the
cast iron flue collar at top rear of stove (fig. 5).
a). Crimped end of pipe must be away from
stove.
b). Hand form lower end (fig. 6) of stove pipe
to oval shape (fig. 7) and slide over flue outlet
collar as shown in figure 5.
c). Secure stove pipe to flue collar with
at least three (3) sheet metal screws and seal
with stove cement.
2. Horizontal pipe runs must slope upwards
towards the chimney at least 1/4” per foot of
horizontal run.
3. You must have at least 18 inches of clearance
between any horizontal piping and the ceiling.
4. The pipe cannot extend into the chimney flue
(figure 8).
5. Secure pipe/elbow sections with three (3)
sheet metal screws at each joint to make the
piping rigid. Screws may be no more than a maxi-
mum of 3˝/76mm apart.
6. It is recommended that no more than two (2)
90 degree bends be used in the stovepipe in-
stallation. The use of more than two 90 degree
bends may decrease the amount of draw and
possibly cause smoke spillage. Where pos-
sible, use only corrugated (nonadjustable)
elbows. These provide a better seal.
7. The connector pipe must not pass through
an attic or roof space, trusses, closet, or any
concealed space, or floor, ceiling, wall or com-
bustible construction. (See Chimney Connector
NOTE: CONNECTOR PIPE IS NOT INCLUDED.
TO PURCHASE PIPE, VISIT YOUR LOCAL
HARDWARE, HOME OR BUILDING CEN-
TER. SEE “LOCATING STOVE” PAGE 4 FOR
ADDITIONAL SPECIFICATIONS.
CAUTION: KEEP FURNISHINGS AND OTHER
COMBUSTIBLE MATERIALS AWAY FROM THE
STOVE.
Fig. 5 – Flue Outlet Collar
Fig. 6 – Hand-form pipe to oval shape – Fig. 7
CORRECT WRONG WRONG
Fig. 8 – Stovepipe/Flue Connections
Systems & clearances, page 10.) A UL 103 HT
Listed chimney system must be used from the
first penetration of ceiling or wall to the chimney
cap. Use chimney components from a single
manufacturer. Do not mix brands.
WARNING: DO NOT USE SINGLE WALL CON-
NECTOR PIPE AS A CHIMNEY - A HOUSE FIRE
COULD RESULT.