Vision Fitness ST740 - Manual (Page 14)

14
4
STEP
• Secure top and bottom shield brackets
(Q08) to weight stack tower using bolts
(M5x10), lock washers (5.1x9.3x1.3),
and flat washers (5.3x10x1) provided.
Repeat for all side brackets (Q09).
• Place two rubber weight plate bumpers
(Z39) over the holes in the lower cross
tube of the weight stack tower. With the
horizontal holes of the guide rods (K05) at
the top, place the guide rods over and
through the rubber weight plate bumpers
into the weight stack tower. Let the guide
rods tilt outward from the tower. Slide each
of the 20 weight plates (K02) over both of
the guide rods on top of one another. Place
the header weight plate (K01) over both
guide rods on top of other weight plates.
• Make sure rubber guide rod sleeves
(Z38) are in place in top holes of the
weight stack tower. Lift the guide rods into
top of weight stack tower until holes in the
guide rod are lined up with the horizontal
holes on the top of the weight stack tower.
Insert a bolt (M8X62) and flat washer
(8.4X15.5X1.6) through each guide rod
and fasten with a flat washer
(8.4X15.5X1.6) and a nut (M8).
GREEN BAG
Z38 Z38
K05 K05
K01 K01
Q09 Q09
Q08 Q08
K02 K02