Vision Fitness ST740 - Manual (Page 18)

18
J02 J02
Z33 Z33
Z32 Z32
Z32 Z32
J03 J03
AT3 AT3
AT2 AT2
AT4 AT4
AT1 AT1
J01 J01
AD1 AD1
8
STEP
• Attach the seat post (AT2) to the seat
frame by inserting four bolts (M10x45)
and four flat washers (10.2x22x2) down
through the top of the frame and fastening
four more flat washers (10.2x22x2) and
four nuts (M10).
• Attach the seatback bracket (AT4) to the
seat post (AT3) with a bolt (M12x85) and
a flat washer (13x26x2.5) and fastening
another flat washer (13x26x2.5) and a
nut (M12) to the opposite side. Don’t
over tighten this joint.
• Take seat bottom (J02) and attach to
seat post (AT3) using four bolts (M10x48).
Secure seat back (J03) on seat back frame
using two bolts (M10x25). Take seat
assembly and insert into seat post support,
making sure to disengage pull pin to allow
insertion. After clicking seat post into a set
position, slide a bolt (M8x62) with flat
washer (8.4x15.5x1.6) through seat post
support and secure with one nut (M8) on
the other side.
• Slide the swing arm pad (J01) onto swing
arm (AD1) and secure with round plastic
stop (Z32), flat washer (8.4x15.5x1.6),
and bolt (M8x15).
• Place round plastic stop (Z33) on each shaft
of foot support base. Slide foot support pads
onto shaft and secure using round plastic
stop (Z32), flat washer (8.4x15.5x1.6),
and bolt (M8x15) on each side.
LIGHT BLUE BAG