VBrick Systems VOD-W Server VBrick v4.2.1 - Manual (Page 17)

Getting Started
VOD-W Admin Guide 9
3. Connect the VOD-W server to the network by plugging the 10/100/1000 BaseT
Ethernet cable into the Ethernet port 1 on the rear of the unit.
4. Connect the monitor cable to the blue video port (front or rear) on the VOD-W server.
Turn the monitor on.
5. Connect a mouse and keyboard to any available USB ports (front or rear) on the VOD-W
server.
6. Insert the dongle key (included in the Product CD case) in any available USB ports (front
or rear). It will illuminate when the unit is powered on.
7. Plug the VOD-W server into a power source, using the power cords provided. (All VOD
servers have redundant power supplies, each with its own cord.)
8. Turn the VOD-W server's main power on by pressing the power switch at the front of
the unit.
Figure 3. VOD 50W (Dell 1950 – Front View)
Figure 4. VOD 125/300W (Dell 2950 – Front View)
9. The VOD-W server will boot and automatically load using the default settings. Wait 5–8
minutes for the unit to fully power up. As new hardware is attached (for example a
keyboard and mouse) the operating system will automatically find and install the drivers.