VocoPro GIG-STAR - Manual (Page 20)

1. POWER button - This button is used to turn the GIG STAR ‘ON’ or place it in STANDBY mode.
NOTE: When in STANDBY mode, the GIG STAR is not completely powered down and it still contains residual power.
2. INPUT button - This button toggles through all of the INPUT channels (DISC, TUNER, AV1, AV2) for available INPUT SOURCES.
3. 7-BAND GRAPHIC EQUALIZER - This GRAPHIC EQ is used to BOOST and/or CUT particular frequencies from SOURCE MUSIC output. Each slide fader
processes a particular frequency range indicated by the number above it. Frequencies from 30Hz - 120Hz constitute the very low to low range. Fre-
quencies from 120Hz to 1kHz are the midrange and frequencies from 1kHz to 16kHz make up the high to very high range. To adjust, slide the fader
up to boost the frequency presence or down to cut the frequency presence.
4. GRAPHIC DISPLAY panel - This panel displays all graphical information regarding system operations, settings and performance.
5. DIRECT TRACK ACCESS buttons - These buttons allow for DIRECT TRACK selection. For tracks 10 and up, press the +10 button. For example, to go
directly to track 13, you would press +10 and 3, and for track 22, you would press +10, +10 and 2.
6. REMOTE SENSOR - This sensor receives infrared signals transmitted by the REMOTE CONTROL transmitter.
NOTE: Obstacles located between the remote control and remote sensor should be avoided as they can prevent signal recognition.
7. BASS control - This control increases/decreases the amount of LOW frequency response applied to the Microphone output.
8. TREBLE control - This control increases/decreases the amount of HIGH frequency response applied to the Microphone output.
9. ECHO LEVEL control - This control adjusts the level of ECHO applied to the MIC channels. Turn control clockwise to INCREASE and counter-clockwise
to DECREASE level.
10. REPEAT control - Use this control to adjust the REPEAT setting of the ECHO effect. As REPEAT adjusts the total number of echo intervals prior
to fade-out, the more REPEAT that is applied, the more ECHO intervals will occur prior to fade-out. Turn control clockwise to INCREASE and counter-
clockwise to DECREASE level.
11. DELAY control - Use this control to adjust the DELAY setting of the ECHO effect. As DELAY adjusts the total begin-to-end length of each echo
interval, the more DELAY that is applied, the longer each ECHO interval will take to complete. Turn control clockwise to INCREASE and counter-clock-
wise to DECREASE level.
12. MUSIC VOL. control - This control increases/decreases the MUSIC VOLUME level. Turn clockwise to increase MUSIC VOLUME and counter-clock-
wise to decrease the MUSIC VOLUME.
13. PLAY button - This button is used to initiate disc PLAYBACK.
14. PAUSE button - This button is used to PAUSE disc PLAYBACK.
15. PREV / NEXT buttons - These buttons are used to either go back to a PREVIOUS track or advance to the NEXT track on a disc during playback.
16. B-SCAN / F-SCAN buttons - These buttons are used to SCAN either BACKWARD or FORWARD through tracks on a disc during playback.
NOTE: Using the B-SCAN and F-SCAN buttons during the playback of a CD+G disc while performing Karaoke is not recommended, as it will
cause the onscreen lyrics to scramble.
17. MUTE button - Silences any audio that is playing while not affecting video playback.
NOTE: The MUTE function does not work when using the Digital Coaxial output.
Front Panel Descriptions
14