VocoPro GIG-STAR - Manual (Page 22)

Rear Panel Descriptions
1. FM Antenna Input - Connect the FM antenna here.
2. AM Antenna Input - Connect the AM antenna here.
3. COAXIAL (Digital) Output - This digital output is for connecting to devices with a digital coaxial input.
4. COMPONENT Video Output - These jacks output VIDEO to a TV monitor via COMPONENT VIDEO cables. COMPONENT VIDEO outputs the
different color signals (U/Pb, V/Pr and R) and luminance signal (Y) separately in order to achieve high fidelity in reproducing colors. The de-
scription of the component video output connectors might differ depending on the TV set or monitor (i.e. R/B/Y or Cr/Cb/Y or R-Y/B-Y/Y etc.).
Component video cables only transmit the video signal; separate cables are needed for audio signals. Please refer to the operating instructions
of the TV set or monitor for details.
5. S-VIDEO Output - This jack outputs to a display device (TV, TFT, etc.) using an S-VIDEO cable. S-VIDEO provides better color separation and
better resolution by separating the color and picture signals of a composite-video signal.
6. FUSE terminal - This terminal houses the GIG STAR’s main system FUSE. NOTE: If fuse replacement is necessary, only replace with the same
type and rating of fuse.
7. POWER switch - This switch turns the GIG STAR’s MAIN POWER ON/OFF.
8. BALANCED AUDIO OUTPUT jacks - These XLR jacks are for connecting MASTER output to an external device with balanced cables.
9. BALANCED MIC 1-2 INPUT (XLR) - These jacks are for connecting microphones via BALANCED XLR-type microphone cables.
NOTE: Both the XLR and ¼” MIC jacks cannot be used simultaneously for any given mic channel.
10. AV 1 INPUT jacks - These jacks are for connecting AUDIO/VIDEO OUTPUT from external AV SOURCES. Connect RCA-style AV cables (R, W,
Y) from these jacks to the AV OUTPUT jacks on your external AV devices.
11. INTERNAL/EXTERNAL SPEAKER selector - This selector toggles the GIG STAR’s master output to be played through either the BUILT-IN
speakers or EXTERNAL speakers connected to the EXTERNAL SPEAKER CONNECTORS.
NOTE: You cannot playback from both INTERNAL and EXTERNAL speakers simultaneously.
12. EXTERNAL SPEAKER connectors - These connectors are for connecting EXTERNAL SPEAKERS to be used for playback instead of the BUILT-
IN SPEAKERS. NOTE: Only connect one 8-ohm rated speaker to each speaker connector.
13. AC POWER outlet - This outlet provides AC POWER to an external device. NOTE: Do not connect any device with a power consumption level
higher than 200W.
14. AC~IN terminal - Connect AC MAIN POWER CORD from the wall outlet to this terminal.
15. VIDEO OUT 1-2 jacks (RCA) - These jacks are for connecting the GIG STAR’s VIDEO OUTPUT to TV or DISPLAY devices. Connect RCA-type
patch cables from these jacks to the VIDEO INPUT jacks on the TV or display devices.
16. AUDIO OUT 1-2 jacks (RCA) - These jacks are for connecting the GIG STAR’s AUDIO OUTPUT to amplifiers, recording or mixing devices. Con-
nect paired RCA-type patch cables from these jacks to appropriate INPUT jacks on external audio devices.
16