Vizio TL-WR641G - Manual (Page 37)

TL-WR641G 108M Wireless Router User Guide
- 29 -
¾ Region - Select your region from the pull-down list. This field specifies the region where
the wireless function of the router can be used. It may be illegal to use the wireless
function of the router in a region other than one of those specified in this field. If your
country or region is not listed, please contact your local government agency for
assistance.
The default region is United States. When you select your local region from the pull-down
list, Click the Save button, then the Note Dialog appears. Click OK.
Figure 4-16
) Note:
Some regions may not use 108Mbps Mode since the operation for the wireless interface in
108Mbps Mode is illegal. Limited by local law regulations, version for North America does not
have region selection option.
¾ Channel - This field determines which operating frequency will be used. It is not
necessary to change the wireless channel unless you notice interference problems with
another nearby access point.
¾ Mode - Select the desired wireless mode. The options are:
• 108Mbps (Dynamic) - Super G ™ , 802.11g and 802.11b wireless stations can connect
to the router.
• 108Mbps (Static) - Only Super G ™ wireless stations can connect to the router.
• 54Mbps (802.11g) - Both 802.11g and 802.11b wireless stations can connect to the
router.
• 11Mbps (802.11b) - Only 802.11b wireless stations can connect to the router.
) Note:
The default is "54Mbps (802.11g)", which allows both 802.11g and 802.11b wireless stations to
connect to the router.
¾ Enable Wireless Router Radio - The wireless radio of this Router can be enabled or
disabled to allow wireless stations access. If enabled, wireless stations will be able to
access the router. Otherwise, wireless stations will not be able to access.
¾ Enable SSID Broadcast - If you select the Enable SSID Broadcast checkbox, the
Wireless Router SSID will broadcast its name (SSID) on the air.
¾ Enable Bridges – If you select the Enable Bridges checkbox, you can input MAC
address of other APs to communicate with them wirelessly in Bridge mode.