Viper 700 ESP - Manual (Page 7)

6
© 2000 Directed Electronics, Inc.
Using Your System
The transmitter buttons used in the instructions in this manual
correspond to the Standard Configuration. Remember, this is not
the only way your transmitter may be set up. It can be custom
configured to meet your needs.
You can activate, or arm, the system by pressing on your trans-
mitter for one second. When the system arms, you will hear a short
siren sound, or chirp, and the parking lights will flash once. If the
vehicle’s power door locks have been connected to the system, the
doors will lock.
While the system is armed, the status LED will flash approximately
once per second, indicating that the system is actively protecting
your vehicle. If you hear a second chirp after arming, and see the
status LED flashing in groups, refer to the Diagnostics section of
this guide. This extra chirp is called Bypass Notification.
The system also can be programmed to arm itself automatically
(called passive arming). If the system is programmed for passive
arming, it will automatically arm 30 seconds after the ignition is
turned off and the system "sees" you leave the vehicle by opening
and closing a door. Whenever the system is in its 30-second
passive-arming countdown, the status LED will flash twice as fast
as it does when the system is armed. The siren will chirp one time
Arming